Ok below is the disk layout and the hardware layout , as you can see the ISCSI software is in place. ( setup next, I agree,finish )
Below You can see the configured Services ( all default )
Sample screen shot from the configured ISCSI targets ( disks) the iscsi disk are vhd file !
For performance reasons I did a NLB on the NIC’s both nic’s are GBit and during a copy I got 39 % network load on one nic after the NLB i had only 10 % max, in this case I did Not use the ISCSI option in the HP nic. I will show you this in the next post.
The Disk layout. and the ISCSI Software MMC
Setting up a new ISCSI Disk used for the VMware server. Right mouse on the Server Create new virtual disk (vhd )
Watch out With the disk size it is in MB WHO uses a MB disk size I’m not so 1 GB = 1000 MB First time I did not read the stuff just next next Finish until the OS install I had only 15 MB disk size ;-(
Give the Disk a name so it is easy to find if you have more than one disk.
On the VMWare Server you have to check out several things. Go to the VMWARE server and configuration , Storage adapter.
You have to enable the ISCSI channel
After this you put in the ISCSI Server that you just create the virtual disk. Then Do a Rescan on the Adapter
If you don’t see the disk than you forgot to add the Service console ISCSI, it is in the manual but easy to forget. And give it an IP number but do not use the Gateway !! this is default the case just remove the Gateway.
So go to the Storage add Storage and it is a disk lun you can see this also in the iscsi server LUN 0- xxx
So after this you must see the disk and it is ready for use.
There is more than one software tool to get ISCSI running. I’m only use this to show how you can do this.